LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1678 (Engine Mechanical - 6.6L (LMM) - Repair Instructions - On Vehicle) >> Engine Oil Pressure Sensor and/or Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Pressure Sensor
    GM1364822Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  1. Apply sealant to the threads of the oil pressure sensor. Refer to Adhesives, Fluids, Lubricants, and Sealers for the correct part number.
  2. Using DT-48827  , install the oil pressure sensor (1). See Special Tools .

    Tighten:  Tighten the sensor to 49 N.m (36 lb ft).

    3. Fig 2: View Of Oil Pressure Sensor Electrical Connector
    GM1335546Courtesy of GENERAL MOTORS CORP.
  3. Connect the oil pressure sensor electrical connector.
  4. Install the left wheelhouse inner panel. Refer to Front Wheelhouse Liner Replacement - Left Side (Chevrolet) or Front Wheelhouse Liner Replacement - Left Side (GMC) .
  5. Check and add engine oil if necessary.
scientia non olet · About LEMON Manuals