LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1667 (Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L - Repair Instructions - On Vehicle) >> Oil Pump, Screen, and Crankshaft Oil Deflector Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Oil Pump Screen & O-Ring Seal
    GM647800Courtesy of GENERAL MOTORS CORP.
  1. Remove the oil pan. Refer to Oil Pan Replacement (4WD)  or Oil Pan Replacement (2WD) .
  2. Remove the engine front cover. Refer to Engine Front Cover Replacement .
  3. Remove the oil pump screen bolt and nuts.
  4. Remove the oil pump screen with O-ring seal.
  5. Remove the O-ring seal from the pump screen.
  6. Discard the O-ring seal.
    7. Fig 2: View Of Crankshaft Oil Deflector & Nuts
    GM683798Courtesy of GENERAL MOTORS CORP.
  7. Remove the remaining crankshaft oil deflector nuts.
  8. Remove the crankshaft oil deflector.
    9. Fig 3: View Of Oil Pump & Bolts
    GM1658173Courtesy of GENERAL MOTORS CORP.
  9. Remove the oil pump bolts (411).
    10. NOTE: Do not allow dirt or debris to enter the oil pump assembly, cap end as necessary.
  10. Remove the oil pump (413)
scientia non olet · About LEMON Manuals