LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1667 (Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L - Repair Instructions - On Vehicle) >> Oil Pump, Screen, and Crankshaft Oil Deflector Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Inspect the engine block oil galley passages. These areas must be free and clear of debris or restrictions.
    Fig 1: View Of Oil Pump & Bolts
    GM1658173Courtesy of GENERAL MOTORS CORP.
  1. Align the splined surfaces of the crankshaft sprocket and the oil pump drive gear and install the oil pump (413).
  2. Install the oil pump (413) onto the crankshaft sprocket until the pump housing contacts the face of the engine block.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the oil pump bolts (411).

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

    4. Fig 2: View Of Crankshaft Oil Deflector & Nuts
    GM683798Courtesy of GENERAL MOTORS CORP.
  4. Position the crankshaft oil deflector and install the nuts until snug.
    5. Fig 3: View Of Oil Pump Screen & O-Ring Seal
    GM647800Courtesy of GENERAL MOTORS CORP.
  5. Lubricate a NEW oil pump screen O-ring seal with clean engine oil.
  6. Install the NEW O-ring seal onto the oil pump screen.
    NOTE: Push the oil pump screen tube completely into the oil pump prior to tightening the bolt. Do not allow the bolt to pull the tube into the pump.
  7. Align the oil pump screen mounting brackets with the correct crankshaft bearing cap studs.
  8. Install the oil pump screen.
  9. Install the oil pump screen bolt and nuts.

    Tighten: 

    1. Tighten the bolt to 12 N.m (106 lb in).
    2. Tighten the nuts to 25 N.m (18 lb ft).

  10. Install the engine front cover. Refer to Engine Front Cover Replacement .
  11. Install the oil pan. Refer to Oil Pan Replacement (4WD)  or Oil Pan Replacement (2WD) .
scientia non olet · About LEMON Manuals