LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1667 (Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L - Repair Instructions - On Vehicle) >> Drive Belt Replacement - Accessory >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Accessory Drive Belt
    GM833370Courtesy of GENERAL MOTORS CORP.
  1. Open the hood.
  2. Remove the air cleaner outlet duct. Refer to Air Cleaner Resonator Outlet Duct Replacement .
  3. Install a breaker bar with hex-head socket to the drive belt tensioner bolt.
  4. Rotate the drive belt tensioner clockwise in order to relieve tension on the belt.
  5. Remove the drive belt (1) from the pulleys and the drive belt tensioner.
  6. Slowly release the tension on the drive belt tensioner.
  7. Remove the breaker bar and socket and from the drive belt tensioner bolt.
  8. Clean and inspect the belt surfaces of all the pulleys.
scientia non olet · About LEMON Manuals