LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1667 (Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L - Repair Instructions - On Vehicle) >> Camshaft Position Actuator Magnet Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of CMP Actuator Magnet, Bolts, Gasket & Oil Seal
    GM1658168Courtesy of GENERAL MOTORS CORP.
  1. Remove the water pump. Refer to Water Pump Replacement (LMM) or Water Pump Replacement (V8) .
  2. Disconnect the engine harness electrical connector from the camshaft position (CMP) actuator magnet.
  3. Remove the CMP actuator magnet bolts (751) and magnet (752).
  4. Remove and discard the CMP actuator magnet gasket (753).
scientia non olet · About LEMON Manuals