LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1653 (Engine Control System & Fuel System - Hybrid (Hp2) 6.0L (LZ1) - DTC P0315 To DTC P1255/DTC P064A) >> DTC P0641 or P0651 (ECM) >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, open the hood to disable the Auto-Stop function. Refer to Hybrid Modes of Operation Description .
  2. Ignition ON, verify the scan tool hood position parameter displays Open.
  3. Ignition ON, observe the scan tool 5-volt reference 1 and 2 circuit status parameters. The parameters should display OK.
  4. Ignition ON, observe the DTC information with a scan tool. DTC P0641 and P0651 should not set.
  5. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals