LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1649 (Engine Control System & Fuel System - Hybrid (Hp2) 6.0L (LZ1) - DTC P0010 To DTC P0308) >> DTC P0134, P0140, P0154, or P0160 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: All modules must be powered down or misdiagnosis may result.
  1. Ignition OFF, disconnect the scan tool and wait 60 seconds to ensure all modules are powered down.
  2. Ignition OFF, disconnect the harness connector at the appropriate HO2S.
  3. Ignition OFF, test for less than 5 Ω between the low reference circuit terminal A and ground.
    • If greater than the specified range, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  4. Ignition ON, verify the appropriate scan tool HO2S parameter is approximately 450 mV.
    • If less than the specified value, test the signal circuit for a short to ground. If the circuit tests normal, replace the ECM.
    • If greater than the specified value, test the signal circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  5. Ignition ON, install a 3 A fused jumper wire between the signal circuit terminal B and ground. Verify the appropriate scan tool HO2S parameter is less than 60 mV.
    • If greater than the specified range, test the signal circuit for an open/high resistance. If the circuit tests normal, replace the ECM.
  6. If all circuits test normal, replace the appropriate HO2S.
scientia non olet · About LEMON Manuals