LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1649 (Engine Control System & Fuel System - Hybrid (Hp2) 6.0L (LZ1) - DTC P0010 To DTC P0308) >> DTC P0102 or P0103 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT: All electrical components and accessories must be turned OFF and allowed to power down.
  1. Ignition OFF, disconnect the harness connector at the MAF/IAT sensor.
  2. Ignition OFF and all vehicle systems OFF. It may take up to 2 minutes for all vehicle systems to power down. Test for less than 5 Ω between the ground circuit terminal E and ground.
    • If greater than the specified range, test the ground circuit for an open/high resistance.
  3. Ignition ON, verify that a test lamp illuminates between the ignition circuit terminal D and ground.
    • If the test lamp does not illuminate, test the ignition circuit for a short to ground or an open/high resistance.
  4. Ignition ON, test for 4.8-5.2 V between the signal circuit terminal C and ground.
    • If less than the specified range, test the signal circuit for a short to ground or an open/high resistance. If the circuit tests normal, replace the ECM.
    • If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the ECM.
  5. Ignition OFF, connect the red lead of the J 38522  to the signal circuit terminal C at the MAF/IAT sensor harness connector. See Special Tools . Connect the battery voltage supply to B+, and the black lead to ground.
  6. Set the J 38522  signal to 5 V, the Frequency to 5K, and the Duty Cycle to Normal. See Special Tools .
  7. Engine idling, observe the scan tool MAF Sensor parameter. The reading should be between 4,950-5,050 Hz.
    • If not within the specified range, replace the ECM.
  8. If all circuits test normal, test or replace the MAF/IAT sensor.
scientia non olet · About LEMON Manuals