LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1647 (Engine Control System & Fuel System - 4.8L, 5.3L, 6.0L, 6.2L - DTC P1255 To DTC P3449) >> DTC P2534 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify that DTC P0562 is not set.
  2. Ignition OFF, disconnect the harness connector of the K27 fuel pump control module.
  3. Ignition ON, test for greater than 11 V between the IGN voltage circuit terminal 15 and ground.
    • If less than the specified voltage, test the IGN voltage circuit for a short to ground or an open/high resistance. If the circuit tests normal and the ECM-IGN fuse is open, test the voltage circuit for a short to ground. If the circuit tests normal, test or replace the Run/Crank relay.
  4. If all circuits test normal, replace the K27 fuel pump control module.
scientia non olet · About LEMON Manuals