LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1645 (Engine Control System & Fuel System - 4.8L, 5.3L, 6.0L, 6.2L - DTC P0300 To DTC P1175) >> DTC P0685, P0689, or P0690 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, engine OFF, command the powertrain relay ON and OFF, with a scan tool, while observing the following powertrain relay coil control circuit status parameters.
    • Powertrain relay coil control Ckt. Short Gnd Test Status
    • Powertrain relay coil control Ckt. Open Test Status
    • Powertrain relay coil control Ckt. Short Volts Test Status

      Each parameter should toggle between OK and Not Run or Not Run and OK

  2. Ignition ON, observe the DTC information with a scan tool. DTC P0685, P0689 or P0690 should not set.
  3. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.