LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1645 (Engine Control System & Fuel System - 4.8L, 5.3L, 6.0L, 6.2L - DTC P0300 To DTC P1175) >> DTC P0496 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, engine OFF, seal the EVAP system using the Purge/Seal function with a scan tool.
  2. Start the engine.
  3. Observe the FTP sensor with a scan tool. The Fuel Tank Pressure Sensor parameter should be less than 1.7 volts after 90 seconds.
    • If the Fuel Tank Pressure Sensor parameter is greater than the specified range, go to Circuit/System Testing.
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals