LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1645 (Engine Control System & Fuel System - 4.8L, 5.3L, 6.0L, 6.2L - DTC P0300 To DTC P1175) >> DTC P0340 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition OFF, disconnect the harness connector at the B23 camshaft position sensor.
  2. Ignition OFF and all vehicle systems OFF, it may take 2 minutes for all vehicle systems to power down, test for less than 1 Ω on the camshaft position low reference circuit, terminal B, and ground.
    • If greater than the specified value, test the low reference circuit for an open/high resistance. If the circuit tests normal, replace the K20 ECM.
  3. Ignition ON, test for 4.8-5.2 V between the camshaft position 5 V reference circuit terminal A and ground.
    • If less than the specified range, test the 5 V reference circuit for an open/high resistance or short to ground. If the circuit tests normal, replace the K20 ECM.
    • If greater than the specified range, test the 5 V reference circuit for a short to voltage. If the circuit tests normal, replace the K20 ECM.
  4. Ignition ON, test for 4.8-5.2 V between the camshaft position signal circuit terminal C and ground.
    • If less than the specified range, test the signal circuit for an open/high resistance or short to ground. If the circuit tests normal, replace the K20 ECM.
    • If greater than the specified range, test the signal circuit for a short to voltage. If the circuit tests normal, replace the K20 ECM.
  5. Ignition OFF, connect a fused jumper wire to the camshaft position signal circuit terminal C.
  6. Ignition ON, momentarily touch the other the other end of the fused jumper wire to the battery negative post. The scan tool should show the Camshaft Position Active counter incrementing.
    • If the Camshaft Position Active counter increments, test or replace the B23 camshaft position sensor.
    • If the Camshaft Position Active counter does not increment, replace the K20 ECM.
scientia non olet · About LEMON Manuals