LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1643 (Engine Control System & Fuel System - 4.8L, 5.3L, 6.0L, 6.2L - DTC P0010 To DTC P0232/DTC P025A) >> DTC P0230 (Without LY6) >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the ignition OFF, disconnect the harness connector at the FPCM.
  2. With the ignition ON, engine OFF, probe the control circuit of the fuel pump control module terminal 13 with a test lamp that is connected to a good ground. Command the fuel pump ON and OFF with a scan tool. The test lamp should turn ON and OFF with each command.
    • If the test lamp does not turn ON and OFF, test for an open, high resistance, or a short to ground in the fuel pump relay control circuit, an intermittent or a poor connection at the engine control module (ECM). If the circuit tests normal, replace the engine control module.
    • If the test lamp remains illuminated with each command, test for a short to voltage in the control circuit of the fuel pump relay or an intermittent or a poor connection at the ECM. If the circuit tests normal, replace the engine control module.
  3. If all circuits test normal, replace the FPCM.
scientia non olet · About LEMON Manuals