LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1643 (Engine Control System & Fuel System - 4.8L, 5.3L, 6.0L, 6.2L - DTC P0010 To DTC P0232/DTC P025A) >> DTC P0171, P0172, P0174, or P0175 >> Repair Verification

Repair Verification

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
  • After repairs, use the scan tool Fuel Trim Reset function in order to reset the Long Term Fuel Trim.
  • To verify the performance of the catalytic converter has not been affected by the condition that set this DTC, perform the Repair Verification for DTC P0420 or P0430. Refer to DTC P0420 or P0430 .
  1. Install any components or connectors that have been removed or replaced during diagnosis.
  2. Perform any adjustment, programming, or setup procedures that are required when a component or module is removed or replaced.
  3. Turn ON the ignition, with the engine OFF.
    4. NOTE: DO NOT clear codes with the engine running. The codes may reset in the same ignition cycle.
  4. Clear the DTCs.
  5. Turn OFF the ignition for 60 seconds.
  6. Start the engine.
  7. Duplicate the Conditions for Running the DTC and use the Freeze Frame/Failure Records, if applicable, in order to verify the DTC does not reset. If the DTC resets, or another DTC is present, refer to the Diagnostic Trouble Code (DTC) List - Vehicle and perform the appropriate diagnostic procedure.
scientia non olet · About LEMON Manuals