LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1640 (Engine Control System & Fuel System - 4.3L - DTC P0340 To DTC P2544) >> DTC P0685, P0689, or P0690 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If you were sent here from Engine Cranks But Does Not Run, proceed to Circuit/System Testing.
  1. Ignition ON, engine OFF, command the powertrain relay ON and OFF, with a scan tool, while observing the following powertrain relay coil control circuit status parameters.
    • Powertrain relay coil control Ckt. Short Gnd Test Status
    • Powertrain relay coil control Ckt. Open Test Status
    • Powertrain relay coil control Ckt. Short Volts Test Status

      Each parameter should toggle between OK and Not Run or Not Run and OK

  2. Ignition ON, view the DTC information with a scan tool. DTC P0685, P0689, or P0690 should not set.
  3. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals