LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1640 (Engine Control System & Fuel System - 4.3L - DTC P0340 To DTC P2544) >> DTC P0641 or P0651 >> Circuit/System Testing

Circuit/System Testing

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Additional DTCs may set when disconnecting components.
  1. Ignition OFF, disconnect the harness connector of all the sensors connected to the 5 V reference bus for the applicable DTC. Refer to Circuit/System Description.
    2. NOTE: A short to voltage on the signal circuit of certain components may cause this DTC to set.
  2. Ignition ON, test for 4.8-5.2 V between one of the 5 V reference circuits and ground.
    • If less than the specified range, test all of the 5 V reference circuits for a short to ground. If all circuits test normal, replace the K20 ECM.
    • If greater than the specified range, test for a short to voltage on all of the 5 V reference circuits, or the signal circuit for each component associated with the appropriate 5 V reference bus for a short to voltage. If all circuits test normal, replace the K20 ECM.
  3. Connect each component associated with the appropriate 5 V reference bus, one at a time, while monitoring the voltage. The voltage should not change more than 1 V.
    • If the voltage display changes more than the specified range when a component is connected, replace the component.
scientia non olet · About LEMON Manuals