LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1640 (Engine Control System & Fuel System - 4.3L - DTC P0340 To DTC P2544) >> DTC P0420 or P0430 >> Conditions for Running the DTC

Conditions for Running the DTC

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Driving Conditions
    • DTCs P0030, P0031, P0036, P0037, P0038, P0068, P0106, P0107, P0108, P0112, P0113, P0117, P0118, P0120, P0121, P0122, P0123, P0125, P0128, P0130, P0131, P0132, P0133, P0134, P0135, P0136, P0137, P0138, P0140, P0141, P0171, P0172, P0201, P0202, P0203, P0204, P0205, P0206, P0207, P0208, P0220, P0300, P0315, P0326, P0327, P0336, P0340, P0341, P0442, P0446, P0452, P0453, P0455, P0496, P0500 (manual transmission only), P0502, P0506, P0507, P0601, P0602, P0606, P0641, P0722, P0723, P1133, P1134, P1516, P1621, P2135, P2138, P2176 are not set.
    • The engine has been running for more than 2 minutes.
    • The vehicle has been driven at greater than 1,000 RPM with the mass air flow (MAF) greater than 18 g/s for greater than 30 seconds.
    • The vehicle is in Closed Loop.
    • The vehicle has Fuel Trim Learn enabled.
    • The Engine Coolant Temperature (ECT) parameter is between 45-128°C (113-262°F).
    • The Barometric Pressure (BARO) parameter is greater than 70 kPa.
    • The catalytic converter calculated temperature is greater than or equal to 420°C (788°F).
    • The intake air temperature (IAT) is between -20 and +85°C (-4 and +185°F).
    • The battery voltage is greater than 11 volts.
  2. Idle Conditions
    • The vehicle speed is less than 3.2 km/h (2 mph).
    • For automatic transmissions, the transmission is in Reverse, Drive, or Low.
    • The throttle position (TP) is less than 2 percent.
    • The short term fuel trim (FT) is between -10 and +10 percent.
    • This diagnostic attempts one test during each valid idle period until a pass or fail decision has been reached when the above conditions have been met. This diagnostic attempts up to 8 completed tests during each drive cycle.