LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1634 (Rear Suspension System) >> Repair Instructions >> Wheel Stud Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wheel Nut & Studs
    GM1688057Courtesy of GENERAL MOTORS CORP.
  1. Position the wheel stud in the rear axle shaft.
  2. Using washers and a wheel nut, tighten the wheel nut until the wheel stud is firmly seated in the rear axle shaft.
  3. Remove the wheel nut and the washers.
  4. Install the rear axle hub assembly, if removed. Refer to Rear Axle Hub, Bearing, Cup, and/or Seal Replacement .
  5. Install the brake rotor. Refer to Rear Brake Rotor Replacement (JD9) or Rear Brake Rotor Replacement (JH6) or Rear Brake Rotor Replacement (JH7) .
  6. Install the rear brake drum. Refer to Brake Drum Replacement .
  7. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  8. Remove the supports and lower the vehicle.
scientia non olet · About LEMON Manuals