LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1634 (Rear Suspension System) >> Repair Instructions >> Shock Absorber Replacement (1500) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Shock Absorber Mounting
    GM1871861Courtesy of GENERAL MOTORS CORP.
  1. Install the shock absorber.
  2. Install the upper shock absorber nut and bolt.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the lower shock absorber nut and bolt.

    Tighten: 

    • Tighten the upper shock absorber bolts to 115 N.m (85 lb ft).
    • Tighten the lower shock absorber bolts to 115 N.m (85 lb ft).

  4. Remove the support from the rear axle.
  5. Remove the safety stands.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals