LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1633 (Transfer Case - BW 4485-Nr3) >> Repair Instructions - On Vehicle >> Rear Output Shaft Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Front Output Shaft Seal Installation Special Tool
    GM1728916Courtesy of GENERAL MOTORS CORP.
  1. Using the J 45756  , install a NEW front output shaft seal. See Special Tools .
  2. Install the rear propeller shaft. Refer to One-Piece Propeller Shaft Replacement or Two-Piece Propeller Shaft Replacement .
  3. Check the fluid level. Add fluid, if necessary.
  4. Install the transfer case shield, if equipped. Refer to Transfer Case Shield Replacement .
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals