Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Oil Pressure Sensor, Washer & Valve Lifter Oil Filter

Courtesy of GENERAL MOTORS CORP.

Apply sealant to the threads of the NEW oil pressure sensor. Refer to Adhesives, Fluids, Lubricants, and Sealers .

CAUTION: Refer to Fastener Caution .

Using J 41712 or equivalent, install the oil pressure sensor (706) and washer (707).
Tighten: Tighten the sensor to 35 N.m (26 lb ft).

Fig 2: View Of Engine Harness Electrical Connectors & Inlet Hose Clamp

Courtesy of GENERAL MOTORS CORP.

Connect the engine harness electrical connector (1) to the oil pressure sensor.
Tighten: Tighten the sensor to 35 N.m (26 lb ft).
Install the intake manifold. Refer to Intake Manifold Replacement (Without AFM) or Intake Manifold Replacement (With AFM) .