LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1626 (Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> Engine Noise Under Load

Engine Noise Under Load

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Cause Correction
Low oil pressure
  1. Perform an oil pressure test. Refer to Oil Pressure Diagnosis and Testing .
  2. Repair or replace, as required.
Detonation or spark knock Verify the correct operation of the ignition controls. Refer to Symptoms - Engine Controls .
Loose torque converter bolts
  1. Inspect the torque converter bolts and flex plate.
  2. Repair, as required.
Cracked flex plate - automatic transmission
  1. Inspect the flex plate bolts and flex plate.
  2. Repair, as required.
Excessive connecting rod bearing clearance Inspect the following components and repair, as required:
  • The connecting rod bearings
  • The connecting rods
  • The crankshaft
Excessive crankshaft bearing clearance Inspect the following components and repair, as required:
  • The crankshaft bearings
  • The crankshaft journals
  • The cylinder block crankshaft bearing bore
scientia non olet · About LEMON Manuals