LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1625 (Engine Mechanical - 4.3L) >> Repair Instructions - On Vehicle >> Valve Lifter Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: It is normal for NEW lifters to make a slight ticking noise when the engine is first started. Increasing the engine RPM slightly to raise oil pressure should stop the noise.
    Fig 1: View Of Valve Lifters
    GM328593Courtesy of GENERAL MOTORS CORP.
  1. Apply lubricant to the lifter rollers. Refer to Adhesives, Fluids, Lubricants, and Sealers  for the correct part number.
    2. NOTE: If reusing the lifters, install the lifters to their original positions.
  2. Install the lifters.
    3. Fig 2: View Of Valve Lifter Pushrod Guides
    GM328592Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  3. Install the lifter pushrod guides and tighten the bolts to 16 N.m (12 lb ft).
  4. Install the pushrods. Refer to Valve Rocker Arm and Push Rod Replacement .
  5. Install the intake manifold. Refer to Lower Intake Manifold Replacement .
scientia non olet · About LEMON Manuals