LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1625 (Engine Mechanical - 4.3L) >> Repair Instructions - On Vehicle >> Engine Mount Replacement - Left Side >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Right Side (Left Side Similar) Engine Mount Side Bracket & Bolts
    GM310262Courtesy of GENERAL MOTORS CORP.
  1. Install the engine mount side bracket to the engine.
  2. Perform the following procedure prior to installing the engine mount bracket bolts.
    1. Remove all traces of the original adhesive patch.
    2. Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
    3. Apply threadlocker GM P/N 12345382 (Canadian P/N 10953489) or equivalent to the bolts.
    3. CAUTION: Refer to Fastener Caution .
  3. Install the engine mount side bracket bolts and tighten to 50 N.m (37 lb ft).
    4. Fig 2: Engine Mount And Bolts
    GM2448490Courtesy of GENERAL MOTORS CORP.
  4. Install the engine mount (2).
  5. Install the engine mount bolts (1) and tighten to 50 N.m (37 lb ft).
  6. Lower the engine.
    7. Fig 3: Identifying Oil Pan Skid Plate
    GM309158Courtesy of GENERAL MOTORS CORP.
  7. Install the oil pan skid plate and bolts and tighten to 20 N.m (15 lb ft).
  8. Lower the vehicle.
    9. Fig 4: Engine Mount Bracket Bolts
    GM2448454Courtesy of GENERAL MOTORS CORP.
  9. Install the engine mount to engine mount bracket bolts (1) and tighten to 65 N.m (48 lb ft).
scientia non olet · About LEMON Manuals