LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1624 (Engine Exhaust System) >> Repair Instructions >> Exhaust Muffler Replacement (2500/3500 Series 6.0L) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Muffler Assembly Insulators
    GM1856703Courtesy of GENERAL MOTORS CORP.
  1. If the vehicle is a non HD, perform the following steps, otherwise proceed to step 5:
  2. Lubricate the 4 insulators where the muffler assembly hangers are inserted in order to ease installation.
  3. With the aid of an assistant, position and install the muffler assembly.
  4. Install the insulators (1-4) to the front, intermediate, and rear muffler assembly hangers.
    5. Fig 2: View Of Muffler Assembly Insulators
    GM1856702Courtesy of GENERAL MOTORS CORP.
  5. If the vehicle is a HD, perform the following steps:
  6. Lubricate the 3 insulators where the muffler assembly hangers are inserted in order to ease installation.
  7. With the aid of an assistant, position and install the muffler assembly.
  8. Install the insulators (1-3) to the front, intermediate, and rear muffler assembly hangers.
    9. Fig 3: View Of Catalytic Converter To Muffler Nuts
    GM1708979Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  9. Install the catalytic converter to exhaust muffler nuts and tighten to 45 N.m (33 lb ft).
    10. Fig 4: View Of Rear Shock Absorbers Lower Bolts & Nuts
    GM665315Courtesy of GENERAL MOTORS CORP.
  10. Raise the rear axle using the adjustable jack stands, if necessary.
  11. Install the rear shock absorber lower bolts and nuts, if necessary and tighten to 95 N.m (70 lb ft).
    12. Fig 5: Rear Axle Vent Hose (10.5 Inch Ring Gear)
    GM695038Courtesy of GENERAL MOTORS CORP.
  12. If equipped with a 10.5 inch ring gear, install the rear axle vent hose to the rear axle, if necessary.
  13. Connect the vent hose swivel clip to the rear brake crossover pipe, if necessary.
    14. Fig 6: Rear Axle Vent Hose (8.6 or 9.5 Inch Ring Gear)
    GM692548Courtesy of GENERAL MOTORS CORP.
  14. If equipped with a 8.6 or a 9.5 inch ring gear, install the rear axle vent hose to the rear axle, if necessary.
  15. Install the vent hose swivel clip to the rear brake crossover pipe, if necessary.
  16. Remove the adjustable jack stands from under the rear axle, if necessary.
  17. Install the spare tire, if necessary.
  18. Lower the vehicle.
scientia non olet · About LEMON Manuals