LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1623 (Propeller Shaft And Universal Joints) >> Repair Instructions >> Rear Propeller Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the splines of the slip yoke for a sufficient coating of lubricant. If the splines of the slip yoke do not have a sufficient coating of lubricant, lubricate the shaft with lubricant GM P/N 12345879 (Canadian P/N 10953511) or with an equivalent lubricant meeting GM specification 9985830 (RWD w/4-speed Automatic Transmission).
    2. Fig 1: View Of Propeller Shaft To Transmission Or Transfer Case
    GM404287Courtesy of GENERAL MOTORS CORP.
  2. Install the propeller shaft into the transmission or transfer case.

    Align the reference marks made during removal.

    3. Fig 2: Identifying Driveshaft Pinion, Yoke Retainers & Bolts
    GM361391Courtesy of GENERAL MOTORS CORP.
  3. Install the propeller shaft (3) to the rear axle pinion yoke (4).

    Align the reference marks made during removal.

    4. CAUTION: Refer to Fastener Caution .
  4. Install the yoke retainers (2) and bolts (1) and tighten to 25 N.m (18 lb ft).
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals