LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1623 (Propeller Shaft And Universal Joints) >> Repair Instructions >> One-Piece Propeller Shaft Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the splines of the slip yoke for a sufficient coating of grease. If the splines of the slip yoke does not have a sufficient coating of grease, lubricate the shaft with clean grease or transmission fluid.
    2. Fig 1: View Of Propeller Shaft-To-Transfer Case Components
    GM2082951Courtesy of GENERAL MOTORS CORP.
  2. Align the reference marks on the propeller shaft (4), the slip yoke (2), the universal bearing caps (3), the transmission or the transfer case (1).
    3. Fig 2: View Of Propeller Shaft To Transmission Or Transfer Case
    GM404287Courtesy of GENERAL MOTORS CORP.
  3. Install the propeller shaft in the transmission or transfer the case.
    4. Fig 3: Identifying Pinion Yoke & Related Components
    GM2082911Courtesy of GENERAL MOTORS CORP.
    NOTE: Ensure that the reference marks are aligned before installing the propeller shaft.
  4. Align the reference marks on the propeller shaft (1), universal bearing cap (4), pinion flange (5), and the rear axle housing (6).
  5. With the reference marks aligned, install the propeller shaft (1) on the rear axle (6).
    6. CAUTION: Refer to Fastener Caution .
  6. Install the rear propeller shaft bolts (3) and the strap (2).

    Tighten:  Tighten the yoke retainer bolts to 25 N.m (18 lb ft).

  7. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals