LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1612 (Automatic Transmission - 4L60-E/4L65-E/4L70-E - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Vehicle Speed Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of VSS, Bolt & O-Ring Seal
    GM481937Courtesy of GENERAL MOTORS CORP.
  1. Install the O-ring seal (3) onto the VSS (1).
  2. Coat the O-ring seal (3) with a thin film of transmission fluid.
  3. Install the VSS (1).
    4. CAUTION: Refer to Fastener Caution .
  4. Install the VSS bolt (2).

    Tighten:  Tighten the bolt to 11 N.m (97 lb in).

    5. Fig 2: View Of Transmission Harness 20-Way Connector & VSS Electrical Connector
    GM858994Courtesy of GENERAL MOTORS CORP.
  5. Connect the VSS electrical connector (2).
  6. Lower the vehicle.
  7. Refill the fluid as required.
scientia non olet · About LEMON Manuals