Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Installing Generator Cooling Inlet Pipe Into Generator Cooling Inlet Pipe Fitting

Courtesy of GENERAL MOTORS CORP.

NOTE: Discard the TOC retaining clip and install a new retaining clip.

Install the TOC pipe into the TOC pipe fitting.
A distinct snap should be heard or felt when assembling the TOC pipe to the fitting.
To ensure the cooler line is properly installed, give the cooler pipe a gentle pull.