LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1608 (Automatic Transmission - 2ML70 - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Automatic Transmission Range Selector Lever Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle .
    2. Fig 1: Range Selector Lever Cable Heat Shield Bolts
    GM1970183Courtesy of GENERAL MOTORS CORP.
  2. Remove the range selector lever cable heat shield bolts (1).
  3. Remove the range selector lever cable heat shield (2).
    4. Fig 2: Range Selector Lever Cable & Retainer
    GM1970184Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the range selector lever cable (2) from the range select lever.
  5. Remove the range selector lever cable retainer (1).
  6. Remove the range selector lever cable (2) from the cable bracket.
    7. Fig 3: Range Selector Lever Nut
    GM1970155Courtesy of GENERAL MOTORS CORP.
    WARNING: Hold the transmission range selector lever while removing or installing the lever retaining nut. Failure to hold the lever can cause damage to the transmission internal park system components which could allow the vehicle to roll when placed in the park position.
  7. Remove the range selector lever nut (1).
  8. Remove the range selector lever (2).
scientia non olet · About LEMON Manuals