Rear Output Shaft Seal and Bushing Removal

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Output Shaft Seal & Bushing

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Transfer Case Rear Output Shaft Seal CAUTION: Refer to Transfer Case Seal Removal Caution .
2	Transfer Case Rear Output Shaft Bushing The following procedure is for the light duty application, for the heavy duty and super heavy duty applications. Refer to Rear Output Shaft Bushing Replacement (Heavy Duty and Super Heavy Duty) . Follow the steps below for use of the J 45380: remover/installer. Procedure Install the finger section of the J 45380: remover/installer in front of the bushing. Install the tube and forcing screw assembly into the finger section. Ensure the forcing screw is backed out. Using a wrench on the forcing screw, remove the bushing. Tip: Only remove the bushing if faulty. Refer to Transfer Case Rear Half Cleaning and Inspection . Special Tools: J 45380: Transfer Case Rear Bushing Remover and Installer

Callout

Component Name

Transfer Case Rear Output Shaft Seal

CAUTION: Refer to Transfer Case Seal Removal Caution .

Transfer Case Rear Output Shaft Bushing
The following procedure is for the light duty application, for the heavy duty and super heavy duty applications. Refer to Rear Output Shaft Bushing Replacement (Heavy Duty and Super Heavy Duty) .
Follow the steps below for use of the J 45380: remover/installer.

Procedure

Install the finger section of the J 45380: remover/installer in front of the bushing.
Install the tube and forcing screw assembly into the finger section. Ensure the forcing screw is backed out.
Using a wrench on the forcing screw, remove the bushing.

Tip: Only remove the bushing if faulty. Refer to Transfer Case Rear Half Cleaning and Inspection .
Special Tools:
J 45380: Transfer Case Rear Bushing Remover and Installer