Circuit/System Verification
WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Engine running. Let the engine run for at least 1 minute.
- Ignition OFF for at least 30 seconds to allow for the complete shutdown of the TCCM.
- Ignition ON, verify that DTC C0550 is not set.
- If DTC C0550 sets, reprogram the TCCM. If the DTC resets, replace the TCCM. Perform the ATC motor learn procedure.