Circuit/System Verification
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Engine running. Let the engine run for at least 1 minute.
- Ignition OFF for at least 30 seconds to allow for the complete shutdown of the TCCM.
- Ignition ON, verify that DTC C0569 is not set.
- If DTC C0569 sets. perform the ATC motor learn procedure. Refer to Transfer Case High/Low Clutch Reset .