PTO - Preset Mode - Factory Default Settings
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
| Programmable Parameters | Factory Setting | Minimum Value | Maximum Value |
|---|---|---|---|
| PTO Incab Control | ENABLED | DISABLED | ENABLED |
| PTO Remote Control | DISABLED | DISABLED | ENABLED |
| Type of Set Switch Operation | MOMENTARY | MOMENTARY | LATCHING |
| Press "ON" then go to Set 1 Speed | DISABLED | DISABLED | ENABLED |
| Remote Engine Start | DISABLED | DISABLED | ENABLED |
| Remote Engine Shutdown | DISABLED | DISABLED | ENABLED |
| Load feedback | DISABLED | DISABLED | ENABLED |
| Engine Relay | DISABLED | DISABLED | ENABLED |
| Keep Relay engage during braking | DISABLED | DISABLED | ENABLED |
| Action after brake is released | RETURN TO BASE IDLE RPM | RETURN TO BASE IDLE RPM | RETURN TO STANDBY RPM |
| Auto Engine Shutdown Timer | DISABLED | DISABLED | DISABLED |
| Engine Shutdown warning | ENABLED | DISABLED | ENABLED |
| Set Low Fuel level for Engine Shutdown | 15% | 0 | 25% |
| Engine Run Time While PTO is Active - Timer | 1 minute | 1 minute | 7 hours |
| Min. PTO Engage Speed | 500 RPM | 500 RPM | 1800 RPM |
| Max. PTO Engine Speed | 2100 RPM | 1100 RPM | 3100 RPM |
| Max. PTO Engage Speed | 1500 RPM | 500 RPM | 1800 RPM |
| PTO Standby RPM | 850 RPM | 500 RPM - Normal engine idle will override if higher than Standby Speed | 3100 RPM |
| PTO Set 1 Speed | 1250 RPM | 500 RPM - PTO Set Speed 1 cannot be set below PTO Standby speed | 3100 RPM |
| PTO Set 2 Speed | 1700 RPM | 500 RPM - PTO Set Speed 2 cannot be set below PTO Standby speed | 3100 RPM |
| Tap Step | 100 RPM | 4 RPM | 500 RPM |
| Ramp Rate | 200 RPM | 20 RPM | 500 RPM |
| Maximum Vehicle Speed | 129 km/h (80 mph) | 30 km/h (19 mph) | 129 km/h (80 mph) |
| Minimum Remote Accelerator Voltage | 0.25 V | 0.0 V | 2.5 V |
| Maximum Remote Accelerator Voltage | 4.75 V | 2.5 V | 5.0 V |
| Remote Set Switch Transition to Low Voltage (<1.66 V) | SET SPEED 1 | - | STANDBY SPEED, SET SPEED 1, SET SPEED 2 |
| Remote Set Switch Transition to Open State (>1.66 V, <3.33 V) | PTO STANDBY | - | STANDBY SPEED, SET SPEED 1, SET SPEED 2 |
| Remote Set Switch Transition to High Voltage (>3.33V) | SET SPEED 2 | - | STANDBY SPEED, SET SPEED 1, SET SPEED 2 |