LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1602 (Engine Control System & Fuel System - Hybrid (Hp2) 6.0L (LZ1) - Repair Instructions) >> Repair Instructions >> Evaporative Emission Canister Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: EVAP Canister & Shield
    GM1855653Courtesy of GENERAL MOTORS CORP.
  1. If replacing the EVAP canister perform the following steps, otherwise proceed to step 4.
  2. Connect the EVAP canister pipes to the canister. Refer to Plastic Collar Quick Connect Fitting Service .
  3. Install the EVAP canister to the shield.
    4. Fig 2: EVAP Canister & Nut
    GM1855652Courtesy of GENERAL MOTORS CORP.
  4. Install the EVAP canister assembly.
    5. CAUTION: Refer to Fastener Caution .
  5. Install the EVAP canister nut and tighten to 25 N.m (18 lb ft).
    6. Fig 3: Solenoid Pipe Clip, Canister Pipe Quick Connect Fitting & Canister Vent Solenoid Pipe Quick Connect Fitting
    GM1854542Courtesy of GENERAL MOTORS CORP.
  6. Connect the EVAP canister pipe quick connect fitting (4) to the fuel tank EVAP pipe. Refer to Plastic Collar Quick Connect Fitting Service .
  7. Connect the EVAP canister vent solenoid pipe quick connect fitting (3) to the EVAP canister. Refer to Plastic Collar Quick Connect Fitting Service .
  8. Connect the EVAP canister pipe quick connect fitting (2) to the fuel tank EVAP pipe. Refer to Plastic Collar Quick Connect Fitting Service .
  9. Lower the vehicle.
scientia non olet · About LEMON Manuals