LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1602 (Engine Control System & Fuel System - Hybrid (Hp2) 6.0L (LZ1) - Repair Instructions) >> Repair Instructions >> Engine Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Bracket Retainer Tabs, ECM Bracket & Tab
    GM1960213Courtesy of GENERAL MOTORS CORP.
  1. Set the bottom of ECM into the ECM bracket tab (2).
  2. Push the ECM (3) in securing the ECM to the bracket.
    3. Fig 2: View Of Engine Wiring Harness Electrical Connector & ECM
    GM1960211Courtesy of GENERAL MOTORS CORP.
  3. Position the engine wiring harness electrical connectors and engage the retainers securing the connectors (2) to the ECM (1).
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (Single Battery) or Battery Negative Cable Disconnection and Connection (Dual Batteries) or Battery Negative Cable Disconnection and Connection (Auxiliary Battery) .
  5. If a NEW ECM was installed, program the ECM. Refer to Control Module References .
scientia non olet · About LEMON Manuals