LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1597 (Hybrid Energy Storage System) >> Diagnostic Information and Procedures >> DTC P1AE6 or P1AE7 >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, Verify that DTC P1A1F is not set.
  2. Verify that DTC P1AE6 is not set.
    • If the DTC is set, replace the drive motor generator battery control module.
  3. Observe the scan tool 300 V Isolation Test Status parameter. The reading should display Passed.
  4. Operate the vehicle within the Conditions for Running the DTC to verify the DTC does not reset. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.
scientia non olet · About LEMON Manuals