LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1597 (Hybrid Energy Storage System) >> Diagnostic Information and Procedures >> DTC P0ABB, P0ABC, or P0ABD >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different car, the 2010 GMC Sierra and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify that DTCs P0A95, P0C77, and P1A20 is not set.
  2. Verify that DTC P0ABD is not set.
    • If the DTC is set, replace the drive motor generator battery assembly. If the DTC resets, replace the drive motor generator battery control module.
  3. Ignition ON, engine OFF, observe the scan tool Hybrid Battery Pack Calculated and Hybrid Battery Terminal parameters. The readings should be between 169 and 408 V and should be within 50 V of each other.
scientia non olet · About LEMON Manuals