LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1592 (Wheel Drive Shafts) >> Repair Instructions >> Wheel Drive Shaft Replacement (1500) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Wheel Drive Shaft
    GM1736759Courtesy of GENERAL MOTORS CORP.
  1. Install the wheel drive shaft in the steering knuckle.
    2. Fig 2: View Of Hub Nut & Washer
    GM1736696Courtesy of GENERAL MOTORS CORP.
    NOTE: Install the NEW nut and washer, but DO NOT tighten at this time.
  2. Install the NEW nut (1) and washer (2).
    3. Fig 3: View Of Drive Flange & Retaining Bolts
    GM1736718Courtesy of GENERAL MOTORS CORP.
  3. Install the retaining bolts and finger tighten.
    4. Fig 4: Loosening/Tightening Hub Nut
    GM1932Courtesy of GENERAL MOTORS CORP.
  4. Insert a drift or large screwdriver through the brake caliper into one of the brake rotor vanes in order to prevent the wheel drive shaft from turning.
    5. CAUTION: Refer to Fastener Caution .
  5. Tighten the wheel driver shaft retaining bolts and tighten to 79 N.m (58 lb ft).
  6. Tighten the wheel drive shaft retaining nut and tighten to 240 N.m (177 lb ft).
  7. Install the shock module. Refer to Shock Absorber and Spring Assembly Replacement .
  8. Install the stabilizer shaft link from the lower control arm. Refer to Stabilizer Shaft Replacement (1500) or Stabilizer Shaft Replacement (2500, 3500) .
  9. Install the front axle hub cap to the wheel bearing, if equipped.
  10. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  11. Lower the vehicle.
scientia non olet · About LEMON Manuals