LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1588 (Parking Brake System) >> Repair Instructions >> Parking Brake Intermediate Cable Replacement (JH6, JH7) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Park Brake Cable & Intermediate Cable Connector
    GM1862950Courtesy of GENERAL MOTORS CORP.
  1. Release the park brake.
  2. Disable the park brake cable automatic adjuster. Refer to Parking Brake Cable Adjuster Disabling .
  3. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  4. Disconnect the front park brake cable (2) from the intermediate cable connector (1) by drilling a 3 mm (1/8 in) hole through the dimple in the front to intermediate park brake cable connector.
    5. Fig 2: Left Park Brake Cable & Intermediate Cable Connector
    GM1862951Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the left park brake cable (2) from the intermediate cable connector (1) by drilling a 3 mm (1/8 in) hole through the dimple in the front to intermediate park brake cable connector.
  6. Remove the intermediate park brake cable.
scientia non olet · About LEMON Manuals