LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1587 (Front Suspension System) >> Repair Instructions >> Lower Control Arm Replacement (1500) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Lower Control Arm
    GM1870075Courtesy of GENERAL MOTORS CORP.
  1. Install the lower control arm (4).
  2. Install the lower control arm bolts (3).
  3. Install the washers (2).
    4. CAUTION: Refer to Fastener Caution .
  4. Install the lower control arm retaining nuts (1) and tighten to 175 N.m (129 lb ft).
  5. Install the lower ball joint in the steering knuckle.
    6. Fig 2: View Of Lower Ball Joint Retaining Nut
    GM1761079Courtesy of GENERAL MOTORS CORP.
    NOTE: There two types of nuts. One with a captured washer and one without. Use only the nut that is on the vehicle.
  6. Install the lower ball joint nut.
    • For those vehicles with the captured washer, tighten the nut to 125 N.m (92 lb ft).
    • For those vehicles without the captured washer, tighten the nut to 50 N.m plus 130 degrees (37 lb ft).
    7. Fig 3: View Of Lower Shock Absorber Module Mount Bolts
    GM1761077Courtesy of GENERAL MOTORS CORP.
  7. Install the lower shock absorber module mount bolts and tighten to 50 N.m (37 lb ft).
  8. Remove the support for the steering knuckle and upper control arm.
  9. Install the wheel drive shaft, if equipped. Refer to Wheel Drive Shaft Replacement (2500) or Wheel Drive Shaft Replacement (1500) .
  10. Install the stabilizer shaft link to the lower control arm. Refer to Stabilizer Shaft Link Replacement (2500, 3500)  or Stabilizer Shaft Link Replacement (1500) .
  11. Install the tire and wheel. Refer to Tire and Wheel Removal and Installation .
  12. Remove the support and lower the vehicle.
  13. Align the front end. Refer to Wheel Alignment Measurement .
scientia non olet · About LEMON Manuals