Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, and 2010 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .

NOTE: When removing the knuckle, DO NOT remove any of the brake or electrical components from the knuckle. Secure the knuckle assembly to the side.

Remove the knuckle from the vehicle. Refer to Steering Knuckle Replacement .

Fig 1: Removing Lock Tabs From Lower Ball Joint

Courtesy of GENERAL MOTORS CORP.

Using a hammer and a chisel, remove the lock tabs (1) from the lower ball joint.

Fig 2: Removing Lower Ball Joint

Courtesy of GENERAL MOTORS CORP.

Using the CH 41805: remover/installer (1) and the appropriate adapter, remove the lower ball joint (2).