Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Install the rear wheel speed sensor reluctor ring, if equipped.
- For vehicles with the HP2 (Hybrid) option, refer to Rear Wheel Speed Sensor Ring Replacement .
- For vehicles that are NON-Hybrid less than 3900 kg (8600 lbs) GVW, refer to Rear Wheel Speed Sensor Ring Replacement .
- For vehicles that are NON-Hybrid greater than/equal to 3900 kg (8600 lbs) GVW, refer to Rear Wheel Speed Sensor Ring Replacement .

Fig 1: Installing Axle Shaft Bearing Using J 23690 & J 8092

Courtesy of GENERAL MOTORS CORP.

NOTE: Ensure that the axle shaft bearing is fully seated in the rear axle shaft housing.

Using the J 23690: installer (1) and the J 8092: driver (2), install the axle shaft bearing.

Fig 2: Installing Axle Shaft Seal Using J 21128

Courtesy of GENERAL MOTORS CORP.

Using the J 21128: installer, install the axle shaft seal.
Drive the tool into the bore until the axle shaft seal bottoms flush with the tube.
Install the rear axle shaft. Refer to Rear Axle Shaft Replacement .
Install the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement (8.6, 9.5 Inch Axles) or Rear Axle Housing Cover and Gasket Replacement (10.5/11.5 Inch Axle) .
Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
Fill the rear axle. Refer to Differential Oil Replacement (10.5 Inch Axle) or Differential Oil Replacement (11.5 Inch Axle) or Differential Oil Replacement (8.6 Inch Axle) or Differential Oil Replacement (9.5LD Inch Axle) .
Remove the support and lower the vehicle.