LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1585 (Rear Drive Axle) >> Repair Instructions >> Rear Axle Housing Cover and Gasket Replacement (10.5/11.5 Inch Axle) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Axle Cover Bolts, Cover & Gasket
    GM1959512Courtesy of GENERAL MOTORS CORP.
  1. Position the axle housing cover (2) and the gasket (3) on the rear axle.
    2. CAUTION: Refer to Fastener Caution .
  2. Install the NEW axle housing cover bolts (1) and tighten to 40 N.m (30 lb ft).
  3. Fill the rear drive axle with the proper fluid. Refer to Differential Oil Replacement (10.5 Inch Axle)  or Differential Oil Replacement (11.5 Inch Axle)  or Differential Oil Replacement (8.6 Inch Axle)  or Differential Oil Replacement (9.5LD Inch Axle) .
  4. Remove the support and lower the vehicle.
scientia non olet · About LEMON Manuals