Locking Differential Clutch Disc Assembly Assemble (9.5LD Axle)

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Locking Differential Clutch Disc Assembly (9.5 Inch Axle)

Courtesy of GENERAL MOTORS CORP.

Apply proper axle lubricant to the surface of each disc. Refer to Adhesives, Fluids, Lubricants, and Sealers .
Assemble the right side or bell-end side clutch disc assembly as follows:
1. Install the 1st non-carbon eared disc (3) to the side gear (1).
2. Install the 1st splined disc (4).
3. Install the 2nd non-carbon eared disc (5).
4. Install the 2nd splined disc (6).
5. Install the 3rd non-carbon eared disc (7).
6. Install the guide clips (2) to the clutch discs (2-7).
  Apply chassis grease to the guide clips in order to hold the clips in place on the disc ears. Refer to Adhesives, Fluids, Lubricants, and Sealers .