Locking Differential Clutch Disc Assembly Assemble (8.6 Inch Axle)
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Apply the correct axle lubricant to the surface of each disc. Refer to Adhesives, Fluids, Lubricants, and Sealers .
- Assemble the right side or bell-end side clutch disc assembly as follows:
- Install the two-sided carbon eared disc (2) to the side gear (1).
- Install the 1st splined disc (4).
- Install the 2nd splined disc (5).
- Install the one-sided carbon eared disc (6).
- Install the guide clips (3) to the clutch discs (2, 4-6).
Apply chassis grease to the guide clips in order to hold the clips in place on the disc ears. Refer to Adhesives, Fluids, Lubricants, and Sealers .