LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1585 (Rear Drive Axle) >> Repair Instructions >> Locking Differential Cam Unit Disassemble (9.5 Inch Axle) >> Special Tools

Special Tools

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Measure and record the overall length of the locking differential side gear assembly from the front of the locking differential side locking differential side gear to thrust washer.
  2. Remove the guide clips.
    3. Fig 1: Removing Thrust Sleeve
    GM886078Courtesy of GENERAL MOTORS CORP.
  3. Using the J 22912-01:  puller (2), J 45232:  replacer (1) and a hydraulic press, remove the locking differential side gear thrust sleeve.
    4. Fig 2: Disassembled View Of Locking Differential Side Gear Components
    GM2158654Courtesy of GENERAL MOTORS CORP.
  4. Remove the locking differential clutch disc thrust washer (7).
  5. Remove the locking differential side gear thrust sleeve (6).
  6. Remove the locking differential clutch disc set (1).
    7. NOTE: The locking differential clutch disc guide is NOT serviced separately. It is serviced with the locking differential clutch disc assembly.
  7. Remove the locking differential clutch disc guide.
  8. Disassemble the locking differential clutch disc assembly (1).
scientia non olet · About LEMON Manuals