Installation Procedure
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Install the rear axle cover. Refer to Rear Axle Housing Cover and Gasket Replacement (8.6, 9.5 Inch Axles) or Rear Axle Housing Cover and Gasket Replacement (10.5/11.5 Inch Axle) .
- Fill the rear axle with axle lubricant. Use the proper fluid. Refer to Approximate Fluid Capacities and Adhesives, Fluids, Lubricants, and Sealers .
- Install the rear axle fill plug and tighten to 33 N.m (24 lb ft).
- Lower the vehicle.
CAUTION:
Refer to Fastener Caution
.