Installation Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Axle Drain Plug

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the rear axle drain plug (1) and tighten to 33 N.m (24 lb ft).
Fill the rear axle with the proper fluid. Refer to Approximate Fluid Capacities and Fluid and Lubricant Recommendations (USA and Canada) .

Fig 2: Fill Plug

Courtesy of GENERAL MOTORS CORP.

Install the fill plug (1) and tighten to 33 N.m (24 lb ft).
Remove the support and lower the vehicle.