LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2006 >> Sierra 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1584 (Disc Brake System) >> Repair Instructions >> Rear Brake Rotor Replacement (JH7) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Rear Brake Rotor (JH7)
    GM892159Courtesy of GENERAL MOTORS CORP.
    WARNING: Refer to Brake Dust Warning .
  1. Release the park brake.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  3. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  4. Remove the hub and rotor assembly. Refer to Rear Axle Hub, Bearing, Cup, and/or Seal Replacement .
  5. Mark the relationship of the hub to the rotor.
  6. Place the hub and rotor assembly on a hydraulic press.
  7. Press the wheel studs out of the hub and rotor assembly.
  8. Separate the hub from the rotor.
scientia non olet · About LEMON Manuals